FREQUENCY 50.080.20Mhz FREQUENCY STABILITY OVEN CONTROLLED POWER 3W POWER SUPPLY 220V BACKUP N/A CONTROLLER PIC16F84 ANTENNA DIPOLE HEIGHT ABOVE ROOF 3 METER HEIGHT ABOVE GROUND 50 METERS LOCATION KM72jb
- THE BEACON IS MADE FROM OLD MOBILE PHONE BASE STATION TRANSMITTING 8W ON 70MHz BAND.
- THE TRANSMITTER UNIT WAS CHANGED AND ADJUSTED TO WORK ON THE 6 METER BAND.
- THE OSCILLATOR IS BASED ON 50.025 Mhz VXO ASSEMBLED INSIDE A HOME MADE TEMPERATURE CONTROLLED OVEN (42Deg C).
- THE OUTPUT POWER IS ADJUSTED TO 3W OUTPUT TO INSURE LONG LIFE AND TO AVOID ANY OVER HEATING AND MAINTENANCE. TO LOWER THE OUTPUT POWER FROM 8W TO 3W A MODIFICATION WAS MADE TO THE POWER SUPPLY.
- THE CONTROLLER IS BASED ON THE PIC16F84 WITH A VERY SIMPLE SOFTWARE. all the c
- KEYING IS MADE BY SWITCHING THE DC POWER TO THE PRE DRIVER STAGE TO MAINTAIN ALL OTHER STAGES STABLE AND TO INSURE FINE AND CLEAN KEYING.
- THE CONTROLLER GETS ONLY ONE INPUT SIGNAL FROM THE OVEN, THIS SIGNAL IS A STATUS OF THE OVEN READY Y/N, IF THE OVEN IS NOT READY YET, THE CONTROLLER TRANSMIT A CW TEXT THAT ANNOUNCES THAT THE XTL IS NOT STABLE YET PSE WAIT.
- THE ONLY OUTPUT FROM THE PIC16F84 IS THE KEYING SIGNAL THAT IS CONNECTED DIRECTLY TO A SMALL AND LOW COIL CURRENT REED RELAY.
- THE REASON THAT THE CONTROLLER SENDS "VVVVVVVV" AT THE BEGINNING OF VERY TRANSMISSION IS VERY SIMPLE, IT IS TO ALLOW SOME TNC's TO SYNC TO THE CORRECT CW SPEED AFTER THE LONG KEY DOWN.
- BEACON CW TEXT IS:
VVVVVVVVVV DE 4X4SIX DE 4X4SIX BEACON.
INFORMATION;
LOCATION; TEL-AVIV, GRID KM72JB.
FREQUENCY; 50.080.20 MHZ
POWER; 5 W.
ANTENNA; VERTICAL, 50 METER ABOVE GROUND.
MORE INFORMATION; WWW.IARC.ORG/4Z5AY
DE 4X4SIX BEACON, NOW TRANSMITTING 15 SECONDS KEY DOWN. (ar)
(Transmitter will key down for about 15 Seconds.)BEACON FRONT PANEL
BEACON INTERNAL VIEW
THE TRANSMITTER IS AT THE LEFT SIDE
THE POWER SUPPLY IS IN THE MIDDLE
AT THE OTHER SIDE INSIDE THE BOX IS THE
OSCILLATOR INSIDE THE OVEN AND
THE CONTROLLER
page update: 21/04/2001